amana furnace troubleshooting

If you’re looking for help fixing your Amana Furnace, look no further! Our comprehensive Amana Furnace Troubleshooting guide will explain common issues, provide tips, and show you how to read your model’s error codes.

Not heating?  
Most likely, either the electrical system providing your furnace’s power has shorted or the power switch has blown. Try resetting your furnace’s circuit breaker. If it has blown, you will need to replace it.
The furnace’s igniter might either be cracked or faulty. Check the part for cracks, if it is then replace the igniter. If it isn’t cracked, use a multimeter to test for continuity.

Cycling irregularly? 
Your thermostat might be adjusting incorrectly, causing the furnace to cycle on and off too often. If your thermostat has an adjustable calibration scale, adjust the heat anticipator. If this does not stabilize the unit, you may have to replace the thermostat.

Not blowing hot air?  
Your blower motor may have completely burnt out. If this doesn’t seem to be the case, then the connecting belt may have simply broken. Test to see if power is reaching the motor. If it does, but isn’t running, the motor has likely failed. If the motor runs but air doesn’t move, the connecting belt has probably broken. You’ll have to replace the belt.

Blowing too much air?  
The control board regulates the amount of voltage that reaches each functioning part. If the relay that controls the blower motor has failed, it will continually send voltage to the motor. Replace the control board.
The contact that controls the blower motor on your thermostat may be stuck closed, causing the blower motor to run continuously. Use a multimeter to check for continuity. If it appears the thermostat is the issue, replace it.

Leaking water? 
The problem may involve your drain pipe.

Starting and then stopping shortly after?  
Your furnace’s flame sensor monitors the burner, detecting whether a flame is present. If it is either defective or dirty, it will not be able to detect a flame. If dirty, clean the sensor using a fine abrasive pad. If faulty, replace the flame sensor.

amana furnace troubleshooting

 


What Our Clients Are Saying About Us

I would like to recommend your company to anyone

February 13, 2021

Your company KDM Home & Gas has just installed the CV 50 water heater to my house. The installation process was so smooth. You guys put on the carpet runner in order to avoid any scratch and damage to the carpet and the floor. Your professional guidance has highlighted the B Vent should be installed for the chimney exhaust in order to comply with the building & safety code. You have even performed leak test & dial test in order to make sure the whole installation is in a perfect manner. The registration of the warranty is also very convenient and easy.

I really appreciated that you came to my house to inspect the situation and provide the quotation to me before we decide to get the new water heater. The whole process was so smooth and communicate very well. You return all my text message on the same day basis or even within short time. I would like to recommend your company to anyone.

Wing Sang LeungNorth York, Ontario

Work was done neatly. Can barely see the pipe that was installed

February 13, 2021

Work was done neatly. Can barely see the pipe that was installed. Priced really well.

Ellen McaleerOshawa, Ontario

KDM's cost was amazingly reasonable compared to all other quotes

February 13, 2021

The tricky plumbing job was completed carefully and thoroughly . Daniel even did extra to make the job proper, within the quote . He patiently explained the work needed before and after completion . In good time, he returned calls and messages, detailed the work, listed every cost honestly, and answered any questions pleasantly . Daniel and his partner were always courteous, and respectful to keep the work clean in my house .

The replaced part is of high quality, thank you ! And his cost were amazingly reasonable compared to all other quotes.

Don GibsonMarkham, Ontario

I would recommend this company to anyone who is looking for a professional job at a reasonable price

February 13, 2021

KDM did a very professional job paying attention to safety and TSSA codes for this type of work.
At the end of the job they tested all gas fired appliances as they had the main gas off to preform this job, and made sure everything was working proper.

I would recommend this company to anyone who is looking for a professional job at a reasonable price.

Don BlakeWhitby, Ontario

I would recommend KDM Home Gas to anyone looking for quality home repair services

February 13, 2021

Daniel was really great to work with. His communication and genuine care for the work being done made all the difference in the world to me especially as we’ve never had good experiences with contractors in the past.

Daniel showed up when he said he would, and took his time to explain to me what caused my humidifier to malfunction. His customer service skills are superior and his quality workmanship made the experience a pleasant one.

I would recommend KDM Home Gas to anyone looking for quality home repair services to their heating or cooling units.

Giselle DharmiWhitby, Ontario

Thank you guys! We couldn’t be happier

February 13, 2021

Dan and his team were extremely professional, courteous, and clean. They showed up on time, and completed the installation exactly when they said they would finish by. Thank you guys ! We couldn’t be happier.

Maria & Steve HalvorsonPickering, Ontario

I highly recommend KDM Home

February 13, 2021

Daniel, Shane and Steve did a great job replacing our 3 appliances today. They’re true professionals that pride themselves on making sure everything is done correctly, within budget and on time. They answered all my questions and were more than willing to give helpful advice. I highly recommend KDM Home.

Frank HowardWhitby, Ontario

I would recommend KDM Home & Gas to anyone looking for great service at a good price.

February 13, 2021

After our old (20+ years) unit gave out, I used HomeStars to obtain quotes for a replacement. Within 30 minutes of posting, I was speaking with Daniel, who was polite and helpful throughout the process. He offered a fair price and a few different products to choose from, and was able to do the installation the same week. I would recommend KDM Home & Gas to anyone looking for great service at a good price.

Josh TaylorAjax, Ontario

Great guys Daniel and Shane did an excellent job

February 13, 2021

Great guys Daniel and Shane did an excellent job clean efficient and on time also very knowledgeable will have them back to replace furnace.

George TrajkovskiAjax, Ontario

KDM did our fireplace gas line and heat venting

February 13, 2021

We’re finishing our basement and had a gas line out in for a fireplace, as well as a heating vent out in bathroom.

Maria & Steve Halvorson Oshawa, Ontario